CEN, 2016. — 15 p. This document specifies techniques for detection of surface imperfections in welds in ferromagnetic materials, including the heat affected zones, by means of magnetic particle testing. The techniques are suitable for most welding processes and joint configurations. Variations in the basic techniques that will provide a higher or lower test sensitivity are...
CEN, 2011. This European Standard specifies requirements for the inspection during construction, documentation and marking of water-tube boilers as defined in EN 12952-1.
CEN, 2016. — 12 p. = Slovenski standard oSIST prEN 12542:2017. This draft European Standard specifies requirements for the design and manufacture of static welded steel cylindrical tanks, serially produced for the storage of liquefied petroleum gas (LPG) with a volume not greater than 13 m3 and for installation above or below ground.
BSI Standards Limited, 2021. — 22 p. — ISBN 978 0 539 03493 6. This document specifies requirements for electrically heated steam boilers manufactured from stainless steel specifically dedicated for generating steam for sterilizers and disinfectors. This document covers only steam boilers that are heated by immersion heaters and which have a maximum allowable pressure (PS) of...
Настоящий европейский стандарт устанавливает требования к проектированию, изготовлению, проверке и испьпаниям больших перевозимых криогенных сосудов с вакуумной изоляцией обьемом более 1000 л, которые постоянно (встроенные цистерны) или непостоянно (сьемные цистерны) прикреплены к транспортному средству для перевозки. по дороге. Тем не менее, он может бьть использован для...
CEN, 2001. — 18 p. This standard describes the techniques to bе applied for the detection of а leak, using а tracer gas and а tracer gas specific leak detector.
CEN, 1999. — 13 p. This European Standard describes a method for the ultrasonic testing of uncoated flat steel product for internal discontinuities. It is applicable to flat product in nominal thickness range of 6 mm to 200 mm of non-alloyed or alloyed steel, excluding austenitic or austenoferritic steels. However, this standard may be applied to the latter types of steels...
CEN, 1999. — 12 p. This European Standard describes procedures for the detection and location of leaks by the bubble emission techniques. The sensitivity depends on techniques and materials used. Two techniques are described: immersion technique: quantitative measurements can be made using this procedure with particular devices (see informative annex A). liquid application...
Выходные данные неизвестны. Настоящий Европейский стандарт был одобрен европейским комитетом по стандартизации 8 июля 2005 г. - 35 с. Стандарт распространяется на требования к навигационным огням и их испытаниям. Стандарт не применяется к навигационным огням прогулочных судов длиной менее 20 м, которые подпадают под действие только МППСС. Этот стандарт устанавливает требования...
Asociación Española de Normalización. Spanish. 2018. — 38 p. Esta norma es la versión oficial, en español, de la Norma Europea EN 13306:2017 Maintenance. Maintenance terminology. Esta norma anula y sustituye a la Norma UNE-EN 13306:2011. El propósito de esta norma europea consiste en definir los términos genéricos utilizados en todos los tipos de mantenimiento y en la gestión...
Approved by CEN on 24 March 2005. — CEN, 2005. — 14 p. This document specifies minimum requirements for properties and test methods for the evaluation of new readymade terry towels and to new terry fabrics, for contract and domestic use. This document covers woven terry structures only. This document does not cover towels used in the health care sector (see ENV 14237) or...
European standard. English Version. — CEN. — October 2008. — 35 p. This European Standard supplies guidelines for the technical specification to allow the design of racking and shelving in its various forms such as adjustable pallet racking (APR), crane serviced racking, drive-in racking (DIR), cantilever racking and shelving systems, including their various forms of...
European standard. English Version. — CEN. — October 2008. — 61 p. This European Standard gives guidelines for operational aspects relevant to structural safety of storage systems. Such systems operate with heavy mechanical handling equipment working in close proximity to static storage equipment. This European Standard minimizes the risk and consequences of unsafe operation or...
Регламент (ЄС) №305/2011 Європейського парламенту та Ради від 09.03.2011р, що встановлює гармонізовані умови для розміщення на ринку будівельних виробів та скасовує Директиву Ради 89/106/ЄЕС. Офіційний вісник Європейського Союзу, 4.4.2011, с.5-43, Страсбург. Преамбула Розділ І Загальні положення Стаття 1. Предмет Стаття 2. Визначення Стаття 3. Основні вимоги до будівельних...
Prepared by : Technical Committee CEN/TC 205 “Non-active medical devices”. Abstract: This document specifies construction, design, performance requirements and test methods for medical face masks intended to limit the transmission of infective agents from staff to patients during surgical procedures and other medical settings with similar requirements. A medical face mask with...
AENOR Ediciones, 2008. — 116 p. Document scope Está directriz de la Serie de Evaluación de la Seguridad y Salud en el Trabajo (OSHAS) proporciona asesoramiento genérico para la aplicación del estándar OSHAS 18001:2007 El Estándar OSHAS 18002 explica los principios fundamentales del estándar OSHAS 18001 y describe el propósito, elementos de entrada típicos, para cada requisito...
Цей Реґламент надає основу для забезпечення високого рівня захисту здоров'я людей та інтересів споживачів стосовно харчових продуктів, враховуючи, зокрема, різноманітність постачання харчових продуктів, включаючи традиційні продукти, і забезпечуючи при цьому ефективне функціонування внутрішнього ринку. Він встановлює єдині принципи та відповідальність, засоби забезпечення...
This is the standard non-professional use for example, jogging, cycling or other traffic related interaction activities. This would include sports users who need high visibility for cycling, road running, driving etc. The EN 1150 standard provides details for non-professional use, together with criteria for minimum area’s and placement of reflective material to achieve enhanced...
This European Standard describes two test methods on abrasion resistance of materials using the same abrasion apparatus. The first method describes the determination of the abrasion resistance of protective clothing materials. The second method describes abrasion pre-treatment of these materials where the test specimens are used afterwards in other test methods or for evaluating...
This standard is designed to ensure that the gloves themselves do not cause harm to the wearer and are comfortable to wear. Tests and requirements include the pH and chrome VI content of leather plus water vapour transmission and absorption of materials. Also procedures to examine the sizing of the glove and its effect on finger dexterity are covered plus general requirements for...
This European Standard was approved by CENELEC on 2009-04-01. CENELEC members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European Standard the status of a national standard without any alteration. This European Standard applies to a security fog system that is part of an Intruder and Hold-up Alarm.